How To Flush Hot Water Heater Electric. This will cause the water pressure to back up and loosen some stubborn sediment still trapped inside. Once the outpour is clear, turn the water valve off again.
How to Flush a Water Heater The Family Handyman from www.familyhandyman.com
This is where water comes out of the water heater. If you have a gas water heater, turn the thermostat to the vacation mode setting or the lowest setting possible without actually turning. Turn off the cold water supply.
Attach A Drain Or Garden Hose To The Drain Valve On The Side Of The Tank.
If your heater is higher up in your house, gravity should be able to let the water flow. How do i flush my water heater? For a gas water heater, extinguish the pilot light.
It’s Important To Also Set The Thermostat Correctly To Set The Optimal Temperature For Your Water Heater.
Here are valid reasons on why you should flush your water heater. Open a hot water faucet and let it run full blast for about 10 minutes to reduce the water temperature in the tank. With an electric, you’ll be turning off the electricity.
Open The Water Supply Valve And Let The Hot Water Heater Tank Fill For About Five.
This is how to clean a water heater. You must turn off an electric water heater completely before flushing or you will risk burning out the heating element. How to flush a water heater:
Turn Off The Gas, Electricity, And Water.
This will cause the water pressure to back up and loosen some stubborn sediment still trapped inside. Flush the hot water heater often, at least once or twice a year, or based on the incoming water quality. The build up of sediment in the tank can reduce your water heater's energy efficiency and also clog your water lines.
Flush Sediment From The Bottom Of The Heater By Opening The Drain Spigot And Allowing The Water To Flow Until It Runs Clear.
Repeat the process until no water is left to drain. If you have a gas water heater, turn the gas valve to the off position. Finally, give your water heater about 20 minutes to warm up and then turn on a faucet to confirm that hot water is coming out.
