How To Level Uneven Ground With A Box Blade. Attach strings to stretch between the stakes, a few inches above the ground. When temporary uneven ground conditions prevent you from carrying out the work safely, the best course of action is often to delay and reschedule the work.
An uneven patch of ground is ideal for practicing with the ripper teeth of the box scraper. This area does not need to be perfectly square or rectangular unless you are planning on using sod instead of simply replanting your grass. Step 1, stake off your area to level.
For Smoothing An Area You’ve Worked, Make Sure Your Box Blade Is On The Ground And Level From Side To Side, Then Extend The Top Link So The Box Blade Is Angled Slightly Up.
This will keep the disc from cutting too deeply on the edges in uneven areas. Attach the line level to the string to measure the highs and lows of your area. Slips, trips, and falls account for the majority of general industry incidents each year, including 15% of all.
Your Box Blade Angled Forward Slightly By Shortening The Top Link.
With excess soil now placed in the low area, raise the box blade to just above the ground level. Once all bumps have been taken out of your path, pull the scarifiers up and level out the box blade on both sides. Level the uneven patch of ground by lowering the ripper teeth to dig up the soil without setting the blades too deep into the ground so as not to rip the level ground.
After You Make These Adjustments, You Can Drag The Box Blade Over The.
Shouldn't take much more than an hour(if that). If it is in between the 2 lines, the ground is level. Set it about 1 above level ground and drive around in all directions.
The Front Of The Box Is Open With A Row Of Teeth That Can Be Adjusted To Break The Ground As Its Pulled.
This area does not need to be perfectly square or rectangular unless you are planning on using sod instead of simply replanting your grass. Mark out and remove the surface from the area. Make a short pass (approximately 30 yards) at normal operating speed and then stop.
Then Drag That Old Section Of Chainlink Fence Around To Finish It Off.
#308 leveling & grading stone, more than one way to use a rear blade! Level uneven ground by lowering the cutting teeth to dig into the ground without pushing the blades too deep into the ground so as not to tear the flat surface. Work over the area well, thoroughly breaking up the soil.